• Your paint spray gun is ready for re-use after only 25 seconds.
  1.      Flushing and cleaning of material passages and air cap (Ø approx. 21 sec.)
  2.      Dry-blowing, used cleaning liquid is collected (Ø approx. 4 sec.)
• Cleaning of material passages and air cap at  simultaneously saves time
• The special cleaning procedure – the cleaning liquid is mixed with air bubbles – which speeds up the cleaning procedure, thus ensuring that the cleaning liquid can penetrate into the more difficult to access areas of the spray gun. This will help to maintain optimum performance of the spray gun.   

• As the SATA clean RCS is a pneumatic device, it can be mounted inside the spray booth (When used with Waterborne Cleaning)  saving time, effort and money. It also reduces the risk of contamination caused by unnecessary trips back and forth to the paint mixing/cleaning area. 
• Used cleaning liquid is collected in a reservoir within the cleaning device. This avoids additional soiling of the spray booth and the expensive filter mats.  

• Quick and reliable spray gun cleaning when using disposable cups even with critical colour changes, e.g. black/white 
• Possible installation in the spray booth (Waterborne)
• Suitable for both waterborne and solvent borne paint systems (Independently)
• Very efficient cleaning even in  hard to reach areas
• Reservoir for used cleaning liquid avoids additional soiling of the paint booth – savings potentials due to increased filter mat life time 
• No readjustment of the gun inlet pressure and no disconnecting required – automatic pressure adaptation when switching between spraying and cleaning
• Storage space for prepared disposable cups
• Increased paint job frequency and capacity utilisation of the spray booth

1. Useful storage space for disposable cups
2. Functional switch cleaning/drying/spraying: Automatic pressure reduction during cleaning and drying without the necessity to adjust the spray gun inlet pressure
3. Cleaning nozzle: Special cleaning procedure (cleaning liquid mixed with air bubbles) provides extraordinarily intensive and reliable cleaning of areas with difficult access.
4. Flexible cleaning brush for an intense but gentle cleaning , air cap and spray gun neck
5. Splash guard
6. Blowing unit for quick spray gun drying 
7. Reservoir for cleaning liquid clean/used behind the cover plate: used cleaning liquid is collected avoiding additional soiling of paint booth and expensive filter mats.  
8. Spray gun holder (optionally available as spare part – can be mounted on either side of the device) (part no 9886)
9. Air connection for paint spray gun (may not be used to supply respirators independent of surrounding air) 

• Bodyshops with many colour changes requiring a quick and professional spray gun cleaning to avoid paint flaws, e.g. car repair shops, joiner’s workshops, industry and commercial vehicle bodyshops 
• For  use with both waterborne and solvent borne paint systems
• Can also be used inside the spray booths (Waterborne Only) 

Air consumption cleaning: approx. 140 Nl/min (4.9 cfm)
Air consumption drying: approx. 130 Nl/min (4.6 cfm)
Consumption of cleaning liquid per cleaning process: approx. 140 ml (4.7 oz.)
Cleaning time per colour change: approx. 21 sec.
Drying time per colour change: approx. 4 sec.
Operating pressure: min. 6 bar / max. 8 bar (min. 87 psi / max. 116 psi)
Width 310 mm x  depth 225 (180) mm x height 710 mm
Width 12.2"  x  depth 8.86" (7.1")  x height 27.95"