SATA® spray master™ RP®

Multi-task tool for carpenters and painters

The multi-task tool for carpenters and painters Special system for spraying high viscosity material. Ideal for carpenters coating small surfaces and painters with special application problems.


  • With its pressurized cup and wide horn nozzle, working with almost every type of material can be easily and perfectly done by carpenters as well as by painters.
  • Fine atomization for optimum results due to the nozzle’s optimized inner pressure.
  • High economic efficiency thanks to RP™ technology. The high efficiency rates are significantly above the 65% required by VOCVOC means Volatile Organic Compounds; i.e. organic solvents.These solvents like many other substances trigger the formation of ground level ozone in combination with solar radiation.VOC guidelines established by the European Community (EU) are intended to contribute to reducing solvent emissions. These guidelines will be valid beginning November 1, 2004 for new shops and November 1, 2007 for all companies. Meanwhile, the VOC Guidelines have been incorporated into national law in most EU member states.X» legislation.
  • Low Air consumption The air consumption per minute serves as an indication for the quantity of air which the compressor has to supply to the spray gun as a minimum requirement. In case that the actual rate is below, it will affect the air-atomization quality.X»- also suitable for small compressors – for carpenters in the workshops and painters on the site.
  • Due to the pressure-assisted material supply via the pressurized cup, this spray gun with the nozzle size “SM” (~1,3) is suitable for almost any sprayable material– only the pressure in the cup is adjusted according to the material ViscosityMaterial viscosity is the time (in seconds) it takes the material to completely flow out of a standardized container. There are different measuring methods available. Please find the corresponding chart attached. X». To achieve a higher material supply and high layer thicknesses, the nozzle sizes 1.7 and 2.0 are additionally available.
  • 100% hand checked nozzle sets ensure the constant high, well-known SATA quality – for complete guns as well as spare nozzle sets.
  • The durable air caps are made of brass (not of aluminium) thus ensuring a long life time.
  • Suitable for Waterborne PaintsIt goes without saying that you can apply any waterborne paint with a SATA paint spray gun. There is only one limitation in this respect: Please do not use the same spray guns for the application of solvent-based as well as waterborne paints. We recommend working with two completely separate sets of spray guns, in line with the two separate paint systems.The CCS (Color Code System) which comes with each high-performance spray gun offers a clever solution to assist you in clearly marking your different spray guns. X» - paint needle and nozzle are made of stainless steel and the nickel-plated spray gun body has been refined with an aditional special coating.
  • Self-adjusting air and material packings with a long lifetime significantly reduce the need for servicing.
  • The carefully polished nickel-plated spray gun surface also reduces the need for cleaning.
  • The spray pattern can be adjusted to any object with the round/ flat spray fan control.
  • The integrated micrometer helps adjust the air flow.